Rocker Switch Plasma Stencil - .580" - Rectangular Plasma Cutter Guide Template

The rocker stencil has .050" offset so the switch will fit tight without sanding. The Plasma Stencil will guide your hand held plasma cutter to quickly and accurately cut a perfect rocker switch hole. Available for most plasma cutters that have a drag shield attachment. Laser cut and etched from 1/8" (11ga.) cold rolled steel. The end result is a quick, clean and accurate cut that can be done anywhere. Made in the USA. Designed for use with a drag shield attachment use the chart in the pictures to determine the proper size for your plasma cutter. If your plasma cutter is not listed, then you will need to measure your drag shield to find the proper size Plasma Stencil to use. Some models do not offer a drag shield attachment and will not work properly with our Plasma Stencils..

• Designed for the most common rocker switches around
• Small rocker 1/2" x 1 1/8" and big rocker 7/8" x 1 1/2"
• Actual cut dimensions: small .46" x 1.13" big .85" x 1.47"
• Laser cut and etched from 1/8" cold rolled steel
• Center line and edge of cut marks allow layout multiple ways